EDM Solution 862 - Arming In STAY Mode 2

System Reporting Information _____________________________________________________ 175
Reporting Information_________________________________________________________________ 176
Zone Status – Bypass Reports __________________________________________________________________ 176
Zone Status – Trouble Reports __________________________________________________________________ 177
Zone Status – Sensor Watch Reports _____________________________________________________________ 178
Zone Status – Alarm Restore Code_______________________________________________________________ 178
Zone Status Reporting Options__________________________________________________________________ 178
Open/Close Reports __________________________________________________________________________ 179
Open/Close Reporting Options__________________________________________________________________ 179
Codepad Duress Report _______________________________________________________________________ 180
Codepad Panic Report ________________________________________________________________________ 180
Codepad Fire Report__________________________________________________________________________ 181
Codepad Medical Report ______________________________________________________________________ 181
Codepad Reporting Options ____________________________________________________________________ 182
System Status – Fuse Fail Report ________________________________________________________________ 182
System Status – Fuse Fail Restore Report _________________________________________________________ 182
System Status – AC Fail Report _________________________________________________________________ 183
System Status – AC Fail Restore Report __________________________________________________________ 183
System Status - Low Battery Report______________________________________________________________ 184
System Status - Low Battery Restore Report _______________________________________________________ 184
System Status - Access Denied__________________________________________________________________ 185
Code Retries ______________________________________________________________________________ 185
System Status Reporting Options ________________________________________________________________ 186
Test Reporting Time__________________________________________________________________________ 187
Test Reporting Dialler Options__________________________________________________________________ 187
Programmable Outputs ___________________________________________________________ 189
Outputs _____________________________________________________________________________ 190
Output Defaults______________________________________________________________________________ 190
Default For Strobe ___________________________________________________________________________ 190
Default For Entry/Exit ________________________________________________________________________ 190
Redirecting Outputs To The Codepad Buzzer ______________________________________________________ 191
Output Event Types __________________________________________________________________________ 192
Output Polarity ______________________________________________________________________________ 199
Output Not Used___________________________________________________________________________ 199
Normally Open, Going Low __________________________________________________________________ 199
Normally Open, Pulsing Low _________________________________________________________________ 199
Normally Open, One Shot Low _______________________________________________________________ 199
Normally Open, One Shot Low With Retrigger ___________________________________________________ 199
Normally Open, One Shot Low With Reset ______________________________________________________ 199
Normally Open, One Shot Low With Alarm _____________________________________________________ 200
Normally Open, Latching Low________________________________________________________________ 200
Normally Low, Going Open __________________________________________________________________ 200
Normally Low, Pulsing Open _________________________________________________________________ 200
Normally Low, One Shot Open _______________________________________________________________ 200
Normally Low, One Shot Open With Retrigger ___________________________________________________ 200
Normally Low, One Shot Open With Reset ______________________________________________________ 200
Normally Low, One Shot Open With Alarm _____________________________________________________ 200
Normally Low, Latching Open________________________________________________________________ 200
Timing Of Outputs ___________________________________________________________________________ 201
Pulsing Polarities ____________________________________________________________________________ 201
One Shot Polarities ___________________________________________________________________________ 202
System Event Timers _____________________________________________________________ 203
System Event Timers __________________________________________________________________ 204
Programming Entry/Exit Timers ________________________________________________________________ 204
Entry Timer 1 _______________________________________________________________________________ 204
Entry Timer 2 _______________________________________________________________________________ 204
Exit Time __________________________________________________________________________________ 205
Entry Guard Timer For STAY Mode _____________________________________________________________ 205
Delay Alarm Reporting Time ___________________________________________________________________ 205
Sensor Watch Time __________________________________________________________________________ 206
Codepad Lockout Time _______________________________________________________________________ 206