Terminals and Descriptions 233
Term Description
STAY Mode 1
Is a condition that automatically isolates certain zones when your system is armed in STAY Mode
1. These zones can only be programmed by your installer.
STAY Mode 2
Is a condition that automatically isolates certain zones when your system is armed in STAY Mode
2. These zones are programmed by the Master Code holder.
Telco Arming Sequence
Telco arming is a feature that automatically diverts your telephone number to another telephone
when the system is armed in AWAY Mode - same as using call forwarding.
Telco Disarm Sequence
Telco disarm automatically un-diverts your telephone upon disarming your system.
Unsealed
Refers to zone status. If a zone is unsealed, the detection devices are violated and the zone
indicator will be illuminated (i.e. a reed switch is open or a detector has noted an intrusion).
User Code
A numerical code that is used to arm and disarm the system in AWAY Mode, STAY Mode 1 or
STAY Mode 2.
Zones
A monitored input used to trigger an alarm condition. A zone may be set up only to activate an
alarm when the system is armed or to operate irrespective of the system being armed or disarmed.
24 Hour Zone
A monitored input where tamper switches and emergency switches may be connected. If at an
y
time, (whether your system is armed or disarmed) one of these switches is violated, an alarm
condition will be generated.
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
