24
Solution 862
Installation Manual
To change data in the current location, enter the new value (0 – 15) followed by the
button. This will store the new data into the location and still leave you positioned at the same
location. You will notice that the new information programmed will be displayed on the
codepad indicators (e.g. If you enter the value
14
followed by the button, both
ZONE
4 and the
MAINS
indicator will illuminate).
To move to the next location, press the
button. The data in the next locations data will
now be displayed.
To exit the Installer’s Programming Mode, enter command
960
followed by the
button. Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish. The
system will now return to the disarmed state and is now ready for use.
Refer to Installer’s Programming Commands on page 29 for further information on commands
that can be performed during access of Installer’s Programming Mode.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...