EDM Solution 862 - Page 258

258
Solution 862
Installation Manual
Determine Type ...................................................... 109
Internal Crystal To Keep Time....................................218
Exit .........................................................................109
Introduction...................................................................16
FAULT Indicator.................................................... 45, 49
Invalid Code................................................185, 206, 216
Features
Isolate In STAY Mode 1.............................................171
Solution 404.............................................................. 17
Isolating Allowed........................................................171
Fire Alarm .................................................................... 59
Isolating Zones..............................................................60
Forced Arming.................................. 52, 55, 57, 171, 232
Code To Isolate .........................................................62
Fuse Fail ....................................................................... 65
Standard Method .......................................................61
G
K
Glossary Of Terms...................................................... 231
Keyswitch Zone ..........................................................164
H
Options....................................................................169
Hand Held Dialler Tester............................................ 226
L
Hand Held Programmer........................................25, 225
Latching Outputs
Hand Held Radio Remote Control.............................. 232
Resetting..................................................................109
Hand Held Transmitters.............................................. 224
Lockout Dialler ...................................................167, 232
Handover .................................................................... 162
Lockout Siren......................................................167, 232
Delay....................................................................... 232
Low Battery...................................................................64
Delay To Be Sequential.......................................... 217
Report......................................................................184
Handshake
Restore Report.........................................................184
Extend Time To Wait ............................................. 146
Handshake Tone For Receiver 1................................. 132
M
Handshake Tone For Receiver 2................................. 135
MAINS Indicator ....................................................45, 48
Hold Down Function
Master Code ................................................................232
Arm In AWAY Mode.............................................107
Master Code Function
Arm In STAY Mode 1............................................107
Changing & Deleting Remote Radio Codes..............92
Arm In STAY Mode 2............................................107
Changing & Deleting User Codes.............................90
Bell Test.................................................................. 108
Changing Domestic Telephone Numbers..................94
Codepad Buzzer Tone Change ............................... 110
Event Memory Recall .............................................106
Fault Analysis Mode............................................... 109
Setting Date and Time.............................................104
Horn Speaker Test .................................................. 107
Turning Outputs ON/OFF .......................................102
Initiate Modem Call................................................109
Walk Test Mode......................................................105
Reset Latching Outputs........................................... 109
Medical Alarm ..............................................................59
Send Test Report .................................................... 110
Modem Call.................................................................109
Strobe Test..............................................................108
Modem Module...........................................................117
Turning Day Alarm On/Off .................................... 108
Monitoring Station ......................................................232
Horn Speaker ................................................................ 64
Monitor................................................................... 215
N
Test ......................................................................... 107
New Zealand Telepermit Notes...................................244
Night Arm Station...............................................218, 225
Installer Code.............................................................. 150
O
Installer Code Function
OFF Indicator/Zone Sealed ...........................................49
Change Telco Arm/Disarm Sequence................. 80, 96
ON Indicator/Zone In Alarm.........................................49
Changing Domestic Phone Numbers........................ 78
Open/Close Reports ....................................................179
Event Memory Recall............................................... 88
In STAY Mode........................................................146
Satellite Siren Service Mode..................................... 86
Only If Previous Alarm Has Occurred ....................146
Set First Test Report ................................................. 77
Reporting Options ...................................................179
Setting STAY Mode 2 Zones............................ 85, 101
Operating Remote Outputs Via Transmitter .................73
Telephone Monitor Mode......................................... 87
Option Bits ....................................................................28
Walk Test Mode ....................................................... 87
Optional Equipment
Installer's Programming Commands
2 Channel Radio Interface.......................................224
958 - Enable/Disable Zone Status............................. 30
2 Wire Smoke Detector Interface............................227
959 - Test Programming Key.................................... 31
304 Mhz RF Receiver .............................................224
960 - Exit Installer's Programming Mode................. 33
Alarm Link Software...............................................225
961 - Reset Control Panel Back To Factory Default. 33
Cellular Diallers ......................................................226
962 - Copy Panel Memory To Programming Key....34
CP5 Eight Zone LCD Codepad...............................225
963 - Copy From Programming Key To Panel......... 35
CP5 Eight Zone LED Codepad...............................225
964 - Erase Programming Key.................................. 36
EDMSAT - Satellite Siren.......................................225
965 - Set Up Domestic Dialling................................ 37
Hand Held Dialler Tester ........................................226
966 - Automatic Stepping Of Locations ................... 38
Hand Held Programmer ..........................................225
999 - Display Panel Type/Software Version Number
Hand Held Transmitters - 304 Mhz.........................224
..............................................................................40
Night Arm Station...................................................225
ISSUE130 Electronics Design and Manufacturing Pty Limited
I