Emerson unidrive m200 - Binary Sum

Binary sum
The binary sum function is always active even if the destination is not routed to valid a parameter. The update rate for the binary sum is always 4ms.
The output of the binary sum block is given by
BinarySumOutput (09.032) = BinarySumOffset (09.034) + (BinarySumOnes (09.029) x 1) + (BinarySumTwos (09.030) x 2) + (BinarySumFours
(09.031) x 4)
BinarySumDestination (09.033) defines the destination for the binary sum output. The routing for this destination is special if the maximum of the
destination parameter ≤ 7 + [BinarySumOffset (09.034)] as follows:
Destination parameter = BinarySumOutput (09.032), subject to the parameter minimum
Otherwise BinarySumOutput (09.032) is routed in the same way as any other destination where the destination target is at its full scale value when the
BinarySumOutput (09.032) = 7 + Offset.
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10
127