Emerson unidrive m200 - Timer 1 Output; Timer 1 Destination; Timer 2 Start Date; Timer 2 Start Time;Timer 2 Stop Date

time period that spans the ends of the repeat period as shown in the example above. It should be noted that if this method is used to allow the active
period to span the ends of the repeat period then if the timer is disabled the output of the timer block before the invert becomes 0, and so the final
output of the timer after the invert is 1.
See UserFunctions1 for more information.
Parameter 09.042 Timer 1 Output
Short description Shows the output state of timer function 1
Mode Open‑loop
Minimum 0 Maximum 1
Default Units
Type 1 Bit Volatile Update Rate Background write
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
Timer1Output (09.042) shows the output of the timer function 1.
Parameter 09.043 Timer 1 Destination
Short description Defines the output destination of timer function 1
Mode Open‑loop
Minimum 0.000 Maximum 30.999
Default 0.000 Units
Type 16 Bit User Save Update Rate Drive reset read
Display Format Standard Decimal Places 3
Coding RW, DE, PT, BU
Timer1Destination (09.043) defines the output destination of timer function 1.
Parameter 09.045 Timer 2 Start Date
Short description Defines the start date for timer 2
Mode Open‑loop
Minimum
0
(Display: 00-00-00)
Maximum
311299
(Display: 31-12-99)
Default
0
(Display: 00-00-00)
Units
Type 32 Bit User Save Update Rate Background read
Display Format Date Decimal Places 0
Coding RW
Timer2StartDate (09.045) defines the start date within the repeat period of timer 2.
See Timer1RepeatFunction (09.039) for more information.
Parameter 09.046 Timer 2 Start Time
Short description Defines the start time for timer 2
Mode Open‑loop
Minimum
0
(Display: 00:00:00)
Maximum
235959
(Display: 23:59:59)
Default
0
(Display: 00:00:00)
Units
Type 32 Bit User Save Update Rate Background read
Display Format Time Decimal Places 0
Coding RW
Timer2StartTime (09.046) defines the start time within the repeat period of timer 2.
See Timer1RepeatFunction (09.039) for more information.
Parameter 09.047 Timer 2 Stop Date
Short description
Mode Open‑loop
Minimum
0
(Display: 00-00-00)
Maximum
311299
(Display: 31-12-99)
Default
0
(Display: 00-00-00)
Units
Type 32 Bit User Save Update Rate Background read
Display Format Date Decimal Places 0
Coding RW
Timer2StopDate (09.047) defines the stop date within the repeat period of timer 2.
See Timer1RepeatFunction (09.039) for more information.
138
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10