EasyManua.ls Logo

Emerson unidrive m200 - Trips (Alphabetical Order)

Emerson unidrive m200
279 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
230 OI.E3
231 Cur.c
232 Dr.Cf
233 Res
234 STO
235 Pb.HF
236 no.PS
237 FI.In
238 Res
239 Res
240 Res
241 Res
242 Res
243 Res
244 Res
245 Pb.bt
246 Der.E
247 Fi.Ch
248 Der.I
249 UPrG
250 R.b.ht
251 Res
252 Res
253 Res
254 Res
255 Rst.L
Trips (alphabetical order)
Trip C.Acc
Value 185
Short description Communication failure with NV media card detected
A communication failure has occurred with a NV media card. If this occurs during a data transfer to the card then the file being written may be corrupted. If this occurs when data is
being transferred from the card then the data transfer may be incomplete. If a parameter file is transferred to the drive and this trip occurs during the transfer the parameters are not
saved to non-volatile memory, and so the original parameters can be restored by powering the drive down and up again.
Recommended actions:
Check the NV media card is installed / located correctly.
Replace the NV media card.
Trip C.by
Value 178
Short description NV media card in use
An attempt has been made to access a file on a NV media card, but the file is already being accessed be an Option Module. No data is transferred.
Recommended actions:
Wait for the Option Module to finish accessing the NV media card and re-attempt the required function.
Trip C.cPr
Value 188
Short description NV media card data and drive data is not the same
A compare has been carried out between a file on a NV media card and the drive and these are different and no other NV media card related trips have occurred.
Recommended actions:
Set Prmm.000 to 0 to reset the trip.
Check to ensure the correct data block on the NV media card has been used for the compare.
Trip C.d.e
Value 179
Short description NV media card data already exists
An attempt has been made to store data on a NV media card, but the file already exists. No data is transferred. The file should be erased first to prevent this trip.
Recommended actions:
Erase the data in data location.
Write data to an alternative data location.
Trip C.dAt
Value 183
Short description Attempt to read non-existant data detected
An attempt has been made to access a non-existent file on a NV media card. No data is transferred.
Recommended actions:
Ensure data block number is correct.
248
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10

Table of Contents

Other manuals for Emerson unidrive m200

Related product manuals