Emerson unidrive m200 - Deceleration Rate Selected; Acceleration Rate Select Bit 0 - 2; Deceleration Rate Select Bit 0 - 1

(02.028) indicating which of these deceleration rates is actually being used.
Parameter 02.031 Deceleration Rate Selected
Short description Indicates which deceleration rate is selected
Mode Open‑loop
Minimum 0 Maximum 8
Default Units
Type 8 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
See AccelerationRateSelected (02.030).
Parameter 02.032 Acceleration Rate Select Bit 0
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RW, NC
See AccelerationRateSelector (02.010).
Parameter 02.033 Acceleration Rate Select Bit 1
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RW, NC
See AccelerationRateSelector (02.010).
Parameter 02.034 Acceleration Rate Select Bit 2
Short description Defines which acceleration rate is used if acceleration rate selector = 0
Mode Open‑loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RW, NC
See AccelerationRateSelector (02.010).
Parameter 02.035 Deceleration Rate Select Bit 0
Short description Defines which deceleration rate is used if deceleration rate selector = 0
Mode Open‑loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RW, NC
See DecelerationRateSelector (02.020).
Parameter 02.036 Deceleration Rate Select Bit 1
Short description Defines which deceleration rate is used if deceleration rate selector = 0
Mode Open‑loop
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate 16ms
Display Format Standard Decimal Places 0
Coding RW, NC
See DecelerationRateSelector (02.020).
40
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10