Emerson unidrive m200 - Safety Information; Warnings, Cautions, and Notes; Electrical Safety and Personnel

4. Two banks are not provided in non-volatile media cards therefore the card could be corrupted if the power is removed when the drive is writing
data to the card.
Loading defaults
A drive reset with 1233 in Parametermm.000 (mm.000) loads the defaults defined for each parameter. If defaults are loaded with 1244 in Parameter
mm.000 (mm.000) then the parameters in the table below have different defaults that are intended for the 60Hz regions.
Parameter Default Drive modes Drive voltage rating
Maximumreferenceclamp (01.006) 60.00Hz All All
StandardRampVoltage (02.008) 775V All 400V
MotorRatedFrequency (05.006) 60.00Hz All All
MotorRatedLoadrpm (05.008) 1800rpm All All
Motor RatedVoltage (05.009) 460V All 400V
M2MaximumReferenceClamp (21.001) 60.00Hz All All
M2MotorRatedFrequency (21.006) 60.00Hz All All
M2MotorRatedLoadrpm (21.008) 1800rpm All All
M2MotorRatedVoltage (21.009) 460V All All
Non-volatile media card data transfer
Details of the data that can be stored on a non-volatile media card and the methods to transfer/access this data are given in Menu 11.
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10
5