Emerson unidrive m200 - Sequencer Logic

Sequencer logic
The diagram below shows the sequencer logic when ReferenceSelectedIndicator (01.049) is not equal to 4 (i.e. keypad control mode is not selected). The definition of the logic symbols are
given in Fig.6.5
The diagram below shows the sequencer logic when ReferenceSelectedIndicator (01.049) =4 (i.e. keypad control mode is selected). The definition of the logic symbols are given in Fig.6.7
84
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10