Emerson unidrive m200 - Reference from an Analog Input; Reference in Rejection Zone; Analog Reference 1;2

See SkipReference1 (01.029).
Parameter 01.035 Reference In Rejection Zone
Short description Displays when the reference is in 1 of the pre-defined rejection zones
Mode Open‑loop
Minimum 0 Maximum 1
Default Units
Type 1 Bit Volatile Update Rate 4ms write
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
See SkipReference1 (01.029).
Parameter 01.036 Analog Reference 1
Short description
Defines the relationship between the final value from analog 1 input and the frequency or speed
reference
Mode Open‑loop
Minimum −VM_SPEED_FREQ_USER_REFS Maximum VM_SPEED_FREQ_USER_REFS
Default 0.00 Units Hz
Type 32 Bit Volatile Update Rate 1ms read
Display Format Standard Decimal Places 2
Coding RO, VM, NC
AnalogReference1 (01.036) or AnalogReference2 (01.037) should be used as the destinations for drive analog inputs when these provide the frequency
reference. The variable maximum/minimum applied to AnalogReference1 (01.036) or AnalogReference2 (01.037) gives the relationship shown below between
the final value from the analog input and the frequency reference.
Parameter 01.037 Analog Reference 2
Short description
Defines the relationship between the final value from analog input 2 and the frequency or speed
reference
Mode Open‑loop
Minimum −VM_SPEED_FREQ_USER_REFS Maximum VM_SPEED_FREQ_USER_REFS
Default 0.00 Units Hz
Type 32 Bit Volatile Update Rate 4ms read
Display Format Standard Decimal Places 2
Coding RO, VM, NC
See AnalogReference1 (01.036).
24
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10