Emerson unidrive m200 - Page 153

126 t126
127 t127
128 t128
129 t129
130 t130
131 t131
132 t132
133 t133
134 t134
135 t135
136 t136
137 t137
138 t138
139 t139
140 t140
141 t141
142 t142
143 t143
144 t144
145 t145
146 t146
147 t147
148 t148
149 t149
150 t150
151 t151
152 t152
153 t153
154 t154
155 t155
156 t156
157 t157
158 t158
159 t159
160 t160
161 t161
162 t162
163 t163
164 t164
165 t165
166 t166
167 t167
24 th Motor thermistor over temperature
218 TH.fb Internal temperature monitoring fault
25 thS Motor thermistor short circuit
11 Tun.1 Autotune trip 1
13 Tun.3 Autotune trip 3
18 Tun.S The Autotune was interrupted
8 U.OI User defined motor Over current trip
36 U.S User saved parameter set has been corrupted
96 UP.us On board user program trip
249 UPrG User program error
Trip0 (10.020) to Trip9 (10.029) store the most recent 10 trips that have occurred where Trip Trip0 (10.020) is the most recent and Trip9 (10.029) is the oldest.
When a new trip occurs it is written to Trip0 (10.020) and all the other trips move down the log, with the oldest being lost.
The date and time when each trip occurs are also stored in the date and time log, i.e. Trip0Date (10.041) to Trip9Time (10.060). The date and time are taken from
Date (06.016) and Time (06.017) (See Date/TimeSelector (06.019)). Some trips have sub-trip numbers which give more detail about the reason for the trip. If a trip
has a sub-trip number its value is stored in the sub-trip log, i.e. Trip0Sub-tripNumber (10.070) to Trip9Sub-tripNumber (10.079). If the trip does not have a sub-trip
number then zero is stored in the sub-trip log.
Trip categories and priorities
Trips are grouped into the categories given in the table below. A trip can only occur when the drive is not tripped, or if it is already tripped and the new trip has a
higher priority than the active trip (i.e. lower priority number). Unless otherwise stated a trip cannot be reset until 1.0s after it has been initiated.
Unidrive M200 Parameter Reference Guide
Issue: 01.05.00.10
153