Trip C.rtg
Value 186
Short description Transfer of data between drives of different ratings detected
A parameter file has been transferred from a NV media card to the drive, but the current and/or voltage rating are different between source and target drive. This trip does not stop
the data transfer, but is a warning that the data for rating dependent parameters may not be the same on the target as the source drive. This trip also applies if a compare (using Pr
mm.000set to 8yyy) is performed between a parameter file on the card on the drive.
Recommended actions:
Reset the drive to clear the trip.
This trip can be suppressed by setting Pr mm.000 to 9666 and resetting the drive.
Trip C.Typ
Value 187
Short description Transfer of data between drives operating in different modes detected
This trip is produced during a compare if the drive mode in the file on the NV media card is different from the current drive mode and the file is a parameter file. This trip is
also produced if an attempt is made to transfer a parameter file where the source and target drive modes are different and the drive mode is outside the range allowed for the target
drive.
Recommended actions:
Ensure the destination drive supports the drive operating mode in the parameter file.
Clear the value in Pr mm.000 and reset the drive.
Ensure destination drive operating mode is the same as the source parameter file.
Trip cL.A1
Value 28
Short description Current loop loss on analog input 1
Indicates that a current loss was detected in current mode on Analog Input 1. In 4-20mA and 20-4mA modes, loss of input is detected if the current falls below 3mA. See
AnalogInput1Mode (07.007) for further details.
Recommended actions:
Check control wiring is correct.
Check control wiring is undamaged.
Check AnalogInput1Mode (07.007).
Check that the current signal is present and greater than 3mA
Trip cL.A2
Value 29
Short description Current loop loss on analog input 2
Indicates that a current loss was detected in current mode on Analog Input 2. In 4-20mA and 20-4mA modes, loss of input is detected if the current falls below 3mA. See
AnalogInput2Mode (07.011) for further details.
Recommended actions:
Check control wiring is correct.
Check control wiring is undamaged.
Check AnalogInput2Mode (07.011).
Check that the current signal is present and greater than 3mA
Trip CL.bt
Value 35
Short description Control word trip (bit 12)
This trip is initiated by setting bit 12 on the control word in ControlWord (06.042) when the control word is enabled (ControlWordEnable (06.043) = On).
Recommended actions:
Check the value of ControlWord (06.042).
Disable the control word in ControlWordEnable (06.043).
Trip Cur.c
Value 231
Short description Current feedback calibration range error
Current calibration range error.
Recommended actions:
Hardware fault - contact the supplier of the drive.
Trip D.Ch
Value 97
Short description Drive has become active while data is being updated
A user action or a file system write is active that is changing the drive parameters and the drive has become active, i.e. DriveActive (10.002) = 1. The user actions that change drive
parameters are loading defaults, changing drive mode, or transferring data from an NV memory card to the drive. The file system actions that will cause this trip to be initiated if the
drive is enabled during the transfer are writing a parameter or macro file to the drive, or transferring a user program to the drive. It should be noted that none of these actions can be
started if the drive is active, and so the trip only occurs if the action is started and then the drive is enabled.
Recommended actions:
Ensure the drive is not enabled when one of the following is being carried out:
Loading defaults
Transferring user programs
To Next Page
Loading...
