RX2530 M4 Upgrade and Maintenance Manual 329
Ê Choose the memory slot according to the configuration rules, see section
"Basic information" on page 270.
12.4.1.3 Installing a memory module
Ê Pull up the required memory cover(s), see figure 218 on page 312.
Figure 237: Opening the memory cooling units
Ê Open the required memory cooling unit:
– Swing the left/right memory cooling unit(s) in the direction of the pump
(see arrows).
– Swing the central memory cooling unit in the direction of the arrow.
Ê Install the memory module, see section "Installing a memory module" on
page 281.
Ê If applicable, install the memory spacers, see section "Installing a memory
spacer" on page 332.
Ê Close the required memory cooling unit(s).
Ê Position the memory cover(s) over the memory modules and press them
carefully down, see figure 232 on page 323.
12.4.1.4 Concluding steps
Ê "Reassembling" on page 57
Ê "Disconnecting the power cord" on page 50
To Next Page
Loading...
