7.10 COMMAND/MONITOR BLOCKING
The device supports a facility to block messages in the monitor direction (data from the device) and also in
the command direction (data to the device). Messages can be blocked in the monitor and command
directions using one of the two following methods
● The menu command RP1 CS103Blocking in the COMMUNICATIONS column
● The DDB signals Monitor Blocked and Command Blocked
7.11 CONFIGURATION
To configure the IED for this protocol, please see the Configuration (on page
55) chapter.
Chapter 7 - SCADA Communications MiCOM P747
206 P747-TM-EN-1