GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-45
PRELIMINARY
3.) Remove the DVI cable clip - be careful to hold the clip screw to prevent it from falling through the
shaft - Figure 8-55.
4.) Remove the Up-Down lever retaining screw (Figure 8-56), then disconnect the Up-Down lever from
the Gas Spring lever as shown in Figure 8-57.
Figure 8-55 Removing the DVI Cable Holder
Figure 8-56 Up-Down Lever Retaining Screw
To Next Page
Loading...
