GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-99
PRELIMINARY
7.) Cut the two tie wraps, as indicated in Figure 8-115.
8.) Using an Allen key, release the screw and nut that secure the arm for the up/down mechanism and
move the arm to one side, as shown in Figure 8-116.
9.) Remove the Lower Arm, as described in the “Lower Arm Removal Procedure” on page 8-193.
Figure 8-115 Location of Tie Wraps
Figure 8-116 Moving the Up/Down Mechanism Arm
Arm Pushed to One Side
Releasing the Arm
Nut
Allen Key
To Next Page
Loading...
