D
IRECTION FR091521, REVISION 1VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-27
PRELIMINARY
4-3-5-4 Using Color Mode
4-3-5-4-1 Color 2D
1) From an optimized 2D image, press Color.
2) Use the trackball (assigned function: Pos) to position the ROI frame over the area to be examined.
3) Press Select. The instruction Size should be highlighted in the trackball status bar.
NOTE: If the trackball control Pointer is selected, press Trackball to be able to select between Position and
Size controls.
4) Use the trackball to adjust the dimension of the ROI.
4-3-5-4-2 Color M-Mode
1) From M-Mode press Color.
2) Use the trackball (assigned function: Pos) to position the color area in the M-Mode display.
3) Press Select. The instruction Size should be highlighted in the trackball status bar.
NOTE: If the trackball control Pointer is selected, press Trackball to be able to select between Position and
Size controls.
4) Use the trackball to adjust the dimension of the color area.
To Next Page
Loading...
