GE Vivid S60N - BIF Connection Map Label Replacement Procedure; Tools; Time Required; Preparation

D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
8-138 Section 8-5 - Electronic Cage Components - Replacement Procedures
PRELIMINARY
8-5-20 BIF Connection Map Label Replacement Procedure
Note: The BIF Connection Map label, is orderable as a separate part.
8-5-20-1 Tools
No special requirements.
8-5-20-2 Time Required
5 min
8-5-20-3 Preparation
Shut down the Vivid™ S60/Vivid™ S70 ultrasound unit, as described in Power Shut Down on page 4 - 7.
8-5-20-4 BIF Connection Map Label Removal Procedure
The label is located on the sub-woofer -see Figure 8-166.
1.) Using a blunt non-metallic instrument, carefully peel off the existing label.
2.) Clean and prepare the sub-woofer’s surface for adhering the replacement label.
8-5-20-5 BIF Connection Map Label Installation Procedure
1.) Remove the self-adhesive replacement label from its packing
2.) Carefully adhere the label to the sub-woofer’s surface making sure that it is position straight and
parallel to the inlaid impression on the sub-woofer.
FRU Part #
Refer to Table 9-14 on page 9-13.
Figure 8-166 Sub-Woofer Showing Location of BIF Connection Map Label