D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
8-168 Section 8-6 - Mechanical Platform Components - Replacement Procedures
PRELIMINARY
8-6-12-5-1 Routing the Probe Cables
When routing the probe cables, it is important to lead the cables upwards from the system’s connecting
ports as shown in Figure 8-203. Always ensure that the cables do not drag on the floor and are
adequately secured by the Probe Cable Holder bracket and Left and Right Cable Hooks.
NOTE: Image for illustration purposes only (pending update).
Observe the following practices:
1.) Lead the right probe cables upwards and thread them via the left and right cable holders as shown
in Figure 8-203.
2.) Open the cable gate (Figure 8-204) on the cable holder and slide the cables into the cable holder.
Figure 8-203 Probe Cables Routed Correctly through Probe Cable Holder Bracket and Cable Hooks
Figure 8-204 Opening the Cable Gate on Probe Cable Holder
Right Cable Hook
Probe Cable
Holder Bracket
Left Cable Hook
To Next Page
Loading...
