D
IRECTION FR091521, REVISION 1VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
4-38 Section 4-3 - Functional Checks
PRELIMINARY
4-3-13 Peripheral Checks
4-3-13-1 Printer Checks
The internal printer is controlled from the P1 key on the Vivid™ S60/Vivid™ S70’s Operator Panel.
Table 4-4 outlines the steps for performing Printer checks.
4-3-13-2 Windows Print Test Page
This checks that the printer is correctly installed and hooked up at the Windows level.
1) Open the Printers folder, either from Start > Settings > Printers or from Utilities > System > Printers.
2) Right-click on a printer and select Preferences.
3) Select Print Test Page (this will send a print to the printer bypassing all of the Scanner software).
4) Observe the printed page.
If the page prints out, the problem you are looking for is probably a configuration issue in windows,
or configuration issue in Utilities > Connectivity.
If the page prints out from Windows, there could not be a problem within Windows. In this event,
you will see an incomplete print out of the test page.
If the page does not print out, there probably is a cabling issue, or a printer configuration issue in
Windows.
NOTE: For the Sony small-format printers, you will see an incomplete Test Page printed out. This is normal.
4-3-13-3 Setup and Check a Printer Service
1) Select Utility > Connectivity
If you get a pop-up asking you to log on, select ADM.
Type the current password.
2) Select the Service tab.
3) In the combo box “Select Service to Add” select “Standard Print” and click on Add.
Table 4-4 Printer Checks
Step Task Expected Result(s)
1
When scanning in 2D Color
Mode, press Freeze to stop
image acquisition.
Image scanning stops with the last
picture on the screen.
2
Press P1 on the Operator Panel The image displayed on the screen is
printed on the assigned printer.
3
Check if the print quality on the
pictures from both printers are of
expected quality.
To Next Page
Loading...
