D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
8-54 Section 8-3 - Control Console Components - Replacement Procedures
PRELIMINARY
2.) Place the Bottom Cover in position on the base of the Operator Panel Keyboard Assembly, aligning
each of the screw holes.
3.) Return and fasten the 9 Phillips screws (previously removed) to secure the bottom cover to the
keyboard assembly - see Figure 8-58.
4.) Carefully turn the Operator Panel Keyboard Assembly over (right-way-up), then install it on the
system:
Figure 8-62 Fitting the Bottom Cover onto the Operator Panel Keyboard Assembly Base
• Operator Panel Keyboard Assembly Installation Procedure on page 8 - 47
To Next Page
Loading...
