D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
1-10 Section 1-1 - Overview
PRELIMINARY
ALWAYS:
• Eject any media from the media storage devices DVD, MOD (if installed).
• Ensure that monitor is in folded and locked position.
• Ensure that the Vivid S60N/Vivid S70N system is well prepared and packed in its original
packaging before transporting. Special care must be taken to correctly position the packing
material, using all screws and brackets.
For further information, refer to Chapter 3 -System Setup.
• Place the probes in their carrying case.
• Secure the system in an full down position and lock the wheels (brake).
• Ensure that the Vivid S60N/Vivid S70N system is firmly secured while inside the vehicle.
• Secure the system with straps or as directed otherwise to prevent motion during transport.
• Prevent vibration damage by driving cautiously. Avoid unpaved roads, excessive speeds,
and erratic stops or starts.
REMEMBER: IF THE FRONT CASTER SWIVEL LOCK IS ENGAGED FOR
TRANSPORTATION, PRESSING THE RELEASE PEDAL ONCE DISENGAGES THE
SWIVEL LOCK. YOU MUST DEPRESS THE RELEASE PEDAL A SECOND TIME TO
ENGAGE THE BRAKE.
BEFORE YOU MOVE OR TRANSPORT THE SYSTEM, MAKE SURE TO LOCK THE LCD MONITOR
ARM FIRMLY AND FLIP DOWN THE MONITOR TO PREVENT DAMAGE TO THE SYSTEM.
See Figure 5-7 on page 5-10 illustrating system in Transportation Mode.
ALWAYS LOCK THE TOP CONSOLE (OPERATOR PANEL) IN ITS PARKING (LOCKED)
POSITION BEFORE MOVING THE SCANNER AROUND.
TO AVOID INJURY WHEN YOU MOVE THE LCD MONITOR AND THE MONITOR ARM, DO NOT PUT
YOUR FINGER, HAND, OR OBJECT ON THE JOINT OF THE MONITOR OR THE MONITOR ARM.
ENSURE THAT NO-ONE TOUCHES THE CONSOLE ARM/FROGLEG WHEN MOVING THE
OPERATOR PANEL.
DO NOT MOVE THE UNIT IF THE OPERATOR PANEL IS IN UNLOCKED POSITION.
KEEP THE HEAT VENTING HOLES ON THE MONITOR UNOBSTRUCTED TO AVOID
OVERHEATING OF THE MONITOR.
THE SYSTEM SHOULD NOT BE MOVED WITH THE OPERATING PANEL EXTENDED.
POSITION THE OPERATING PANEL IN ITS CENTERED AND LOCKED POSITION.
LOWER THE OPERATING PANEL AS MUCH AS POSSIBLE BEFORE MOVING THE
SYSTEM. See Figure 5-7 on page 5-10 illustrating system in Transportation Mode.
-
DO NOT TRANSPORT THE VIVID S60N/VIVID S70N SYSTEM IN A VEHICLE WITHOUT LOCKING
THE CASTERS (WHEELS)
See Figure 5-7 on page 5-10 illustrating system in Transportation Mode.
EQUIPMENT DAMAGE COULD RESULT IF SPECIAL CARE IS NOT TAKEN WHEN
TRANSPORTING THE
VIVID S60N/VIVID S70N SYSTEM IN A VEHICLE.
See Figure 5-7 on page 5-10 illustrating system in Transportation Mode.
To Next Page
Loading...
