LCR-8000 Series User Manual
100
Setting trigger mode
List test step offers REPEAT and SINGLE and AUTO mode.
When the part is tested manually, it is traditionally necessary to
connect the object to be tested, and then press the TRIGGER button
or use the foot switch to start the measurement. Sometimes the
measurement result is wrong because it is not matched, which is
time-consuming and labor-intensive. Switch to AUTO mode and
use automatic trigger to measure, save time and accuracy.
1. Press the Measure button to enter
[MEAS DISPLAY] page, and press the
LIST SET function button on the right
side of the LCD to enter the [LIST SET]
page, and then press the Setup button
to enter [LIST MODE SETUP] page.
2. Use arrow keys to move cursor and
select TRIGGER MODE item on the
[LIST MODE SETUP] page.
3. Use option key on the right of the LCD screen
to select a desired item.
To Next Page
Loading...
