GW Instek LCR Series - Measure Subsystem; Measure:parameter; Off|Rdc|Ls|Lp|Cs|Cp|Q|D|Rs|Rp|Z|Deg|Rad|R|X|Y|G|B|E|U; Measure: Frequency < Frequency Nr3;Disc

COMMAND OVERVIEW
181
MEASure Subsystem
:MEASure:PARAmeter
{OFF|RDC|LS|LP|CS|CP|Q|D|RS|RP|Z|DEG|RAD|R|X|Y|G|B|E|U}
:MEASure:PARAmeter?
Function： It sets or queries the measurement parameter (max.4
items) at present.
Description：
Set parameter OFF, RDC(DC Resistance), Ls(Series Inductance),
Lp(Parallel Inductance), Cs (Series Capacitance), Cp (Parallel
Capacitance), Q (Quality Factor), D (Dissipation Factor), Rs (Series
Resistance) Rp(Parallel Resistance), Z(Impedance), θd(Angle),
θr(Diameter), R(Resistance), X(Reactance), Y (Admittance), G
(Conductivity), B (Susceptance).
Set syntax
:MEASure:PARAmeter RDC,Z,DEG,OFF
RDC is the first measure parameter, the second is Z, the third is
θdeg
，
and the forth is OFF.
Query syntax
:MEASure:PARAmeter?
Return data RDC,Z,DEG,OFF
:
MEASure
:
FREQuency
<
frequency NR3/disc>
:MEASure:FREQuency?
Function： It sets or queries the FREQUENCY.
Description：
Set parameter The
setup value of frequency is
{10.0~30000000.0(depending on the model)|
|MAXimum|MINimum}.
Set syntax
:MEASure:FREQuency 1000
:MEASure:FREQuency1K
:MEASure:FREQuency 1KHZ
:MEASure:FREQuency 1E3
:MEASure:FREQuency MAXimum