SYSTEM CONFIGURATION
145
Setting HANDLER INTERFACE
Set the handle interface to open and close state. Requires Handler
I/O output, need to enable setting. Without I/O output, the
interface circuit can be closed, which can save measurement
processing time about 1-2ms.
1. Press System button at the top right of
the LCD screen to enter the [SYSTEM
CONFIG] setting page.
2. Use up and down arrow keys to select
HANDLER INTERFACE on this
setting page.
3. Use option key on the right of the LCD screen
to select a desired item.
Handle interface to close
Show handle interface pins define
To Next Page
Loading...
