GW Instek LCR Series - USB Interface; Configure USB Interface

LCR-8000 Series User Manual
160
USB Interface
The device is equipped with built-in USB-232 interface which can
directly virtualize the USB port as an RS232 port in the computer.
This virtual port can perform the same functions as RS232 and use
the same settings as the RS232 port. It supports USB2.0 and below
version.
The USB device port on the rear panel is used for remote control.
The USB port is configured as CDC interface.
When configured to CDC, the USB port on the LCR-8200 series will
appear as a virtual COM port to a connected PC. Any terminal
program that can communicate via a serial port can be used for
remote control. Before the LCR-8200 series can be used for remote
control using the CDC USB class, install the appropriate CDC USB
driver included on the User Manual CD.
Configure USB Interface
Background
The Type B USB port on the rear panel is used for
remote control. This interface creates a virtual COM
port when connected to a PC.
Note
The USB interface requires the USB driver to be
installed.
USB
Configuration
PC connector
Type A, host
LCR-8200 series
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high
speed)
USB Class
CDC (Communications
device class)
Hardware flow control
Off
Data Bits
8
Stop bit
1