CORRECTION (OPEN/SHORT)
133
Setting spot no.
The SPOT LOAD compensation point can be set to a maximum of
16 points. If the test frequency and measurement parameters are
not the same, you need to increase the SPOT set point.
1. Press the Measure button to enter
[MEAS DISPLAY] page, and then
press the CORR. function button on
the right side of the LCD to enter the
[CORRECTION] page.
2. Use arrow keys to move cursor and
select SPOT No. item on the
[CORRECTION] page.
3. Use option key on the right of the LCD screen
to select ↑or↓ item switch point number.
To Next Page
Loading...
