GW Instek LCR Series - Setting Trigger Delay

LIST (MULTI STEP MODE)
103
Setting trigger delay
Set the trigger delay time before each list test. The delay time range
is 0ms~5000ms.
Steps
1. Press the Measure button to enter
[MEAS DISPLAY] page, and press the
LIST SET function button on the right
side of the LCD to enter the [LIST
SET] page, and then press the Setup
button to enter [LIST MODE SETUP]
page.
2. Use arrow keys to move cursor and
select TRIGGER DELAY item on the
[LIST MODE SETUP] page.
3. Use the numeric keypad to enter the delay
time.