LCR-8000 Series User Manual
78
Setting sweep delay
Set the sweep test the delay time between each test point and point.
The delay time range is 0ms~5000ms.
1. Press the Measure button to enter
[MEAS DISPLAY] page, and then
press the SWEEP function button on
the right side of the LCD to enter the
[SWEEP DISPLAY] page, and press
the Setup button to enter [SWEEP
MODE SETUP] page.
2. Use arrow keys to move the cursor
and select SWEEP DELAY item on the
[SWEEP MODE SETUP] page.
3. Use the numeric keypad to enter the time (ms).
To Next Page
Loading...
