GW Instek LCR Series

To Next Page

To Previous Page

LCR-8000 Series User Manual

114

Available

options

VALUE

The measured values are compared.

Select this mode, the NOMINAL field

does not need to be set, just set the

UPPER and LOWER upper and lower

limits.

△

The difference between the measured

value and the NOMINAL value is

compared.

Absolute value (Δ) = measure value –

nominal value

Select this mode, the NOMINAL value

and UPPER and LOWER upper and

lower limits must be set.

GW Instek LCR Series - Page 114