GW Instek LCR Series - Page 33

MEASURE (METER MODE)
33
Steps
1. Press the Measure button to enter [MEAS
DISPLAY] page.
2. Use arrow keys to move cursor and select
LEVEL item on the [MEAS DISPLAY]
page.
3. Use option key on the right of the LCD screen to
adjust the level value or use the numeric keypad to
enter the test level and select ALC/RO for this
measurement item.
Available
parameter

Increase 0.1Vac/1mAac of the level value

Decrease 0.1Vac/1mAac of the level value
ALC OFF
ALC function turn off
Shown at the bottom of the screen.
ALC ON
ALC function turn on
Shown at the bottom of the screen.
RO 100Ω
Set output impedance 100Ω
Shown at the bottom of the screen.
RO 25Ω
Set output impedance 25Ω
Shown at the bottom of the screen.