GW Instek LCR Series - Page 46

LCR-8000 Series User Manual
46
△
The difference between the measured
value and the NOMINAL value is
compared.
Absolute value (Δ) = measure value –
nominal value
Select this mode, the NOMINAL value
and UPPER and LOWER upper and
lower limits must be set.
△%
The difference between the measured
value and the NOMINAL value is
compared with the percentage of the
NOMINAL value.
Deviation percentages (Δ%) = Absolute
value (Δ)/nominal value × 100%
Select this mode, the NOMINAL value
and UPPER and LOWER upper and
lower limits must be set.
OFF
Turn off the comparator function