HEIDENHAIN TNC 620 Programming Station

Contents
Example: Linear movement with polar coordinates........................................................................................... 173
Example: Helix.............................................................................................................................................................174
5.6 Path contours – FK free contour programming (option 19)............................................................ 175
Fundamentals..............................................................................................................................................................175
Defining the working plane.......................................................................................................................................176
FK programming graphics....................................................................................................................................... 177
Initiating the FK dialog.............................................................................................................................................. 178
Pole for FK programming.........................................................................................................................................178
Free straight line programming...............................................................................................................................179
Free circular path programming............................................................................................................................. 180
Input possibilities........................................................................................................................................................181
Auxiliary points............................................................................................................................................................184
Relative data................................................................................................................................................................ 185
Example: FK programming 1...................................................................................................................................187
Example: FK programming 2...................................................................................................................................188
Example: FK programming 3...................................................................................................................................189
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
13