Fundamentals | Control model, software and features
14
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Changed functions 73498x-02
The maximum number of characters for the NAME and DOC
fields in the tool table has been increased from 16 to 32, see
"Entering tool data into the table", page 234
The columns ACC were added to the tool table, see "Entering
tool data into the table", page 234
Operation and positioning behavior of the manual probing cycles
has been improved, see "Using a 3-D touch probe (option 17)",
page 654
Predefined values can now be entered into a cycle
parameter with the PREDEF function in cycles,
see Cycle Programming User's Manual
With the KinematicsOpt cycles a new optimization algorithm is
now used, see the Cycle Programming User's Manual
With Cycle 257, CIRCULAR STUD, a parameter is now available
with which you can determine the approach position on the
stud, see User's Manual for Cycle Programming
With Cycle 256 RECTANGULAR STUD, a parameter is now
available with which you can determine the approach position on
the stud, see Cycle Programming User's Manual
With the manual Basic Rotation touch probe cycle, workpiece
misalignment can now be compensated for via a table rotation,
see "Compensation of workpiece misalignment by rotating the
table", page 671
To Next Page
Loading...
Need help?
General
