Fundamentals | Control model, software and features
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
15
New functions 81760x-01
New special operating mode RETRACT, see "Retraction after a
power interruption", page 724
New graphic simulation, see "Graphics (option 20)", page 700
New Tool usage file MOD function in the machine settings
group, see "Tool usage file", page 745
New Set system time MOD function in the systems settings
group, see "Set the system time", page 746
New Graphic settings MOD group, see "Graphic settings",
page 740
With the new cutting data calculator you can calculate the
spindle speed and the feed rate, see "Cutting data calculator",
page 210
Now you can activate and deactivate the active chatter control
(ACC) with a soft key, see "Activating/deactivating ACC",
page 499
With the jump commands new if/then decisions have been
introduced, see "Programming if-then decisions", page 377
The character set of machining Cycle 225 Engraving has been
expanded to include more characters and the diameter sign,
see Cycle Programming User's Manual
New machining Cycle 275 Trochoidal Milling,
see Cycle Programming User's Manual
New Cycle 233 Face Milling,
see Cycle Programming User's Manual
In the drilling cycles 200, 203 and 205 the parameter Q395
DEPTH REFERENCE has been introduced in order to evaluate
the T ANGLE, see Cycle Programming User's Manual
Probing Cycle 4 MEASURING IN 3-D has been introduced,
see Cycle Programming User's Manual
To Next Page
Loading...
Need help?
General
