HEIDENHAIN TNC 620 Programming Station

Programming Qparameters | Additional functions
Error number Text
1137 Touch probe data incomplete
1138 LAC function not possible
1139 Rounding radius or chamfer is too large!
1140 Axis angle not equal to tilt angle
1141 Character height not defined
1142 Excessive character height
1143 Tolerance error: Workpiece rework
1144 Tolerance error: Workpiece scrap
1145 Faulty dimension definition
1146 Illegal entry in compensation table
1147 Transformation not possible
1148 Tool spindle incorrectly configured
1149 Offset of the turning spindle unknown
1150 Global program settings are active
1151 Faulty configuration of OEM macros
1152 The combination of programmed oversizes is not
possible
1153 Measured value not captured
1154 Check the monitoring of the tolerance
1155 Hole is smaller than the stylus tip
1156 Preset cannot be set
1157 Alignment of a rotary table is not possible
1158 Alignment of rotary axes is not possible
1159 Infeed limited to length of cutting edge
1160 Machining depth defined as 0
1161 Tool type is unsuitable
1162 Finishing allowance not defined
1163 Machine datum could not be written
1164 Spindle for synchronization could not be ascer-
tained
1165 Function is not possible in the active operating
mode
1166 Oversize defined too large
1167 Number of teeth not defined
1168 Machining depth does not increase monotonously
1169 Infeed does not decrease monotonously
1170 Tool radius not defined correctly
1171 Mode for retraction to clearance height not possi-
ble
1172 Gear wheel definition incorrect
9
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
295