HEIDENHAIN TNC 620 Programming Station

Programming Qparameters | Preassigned Q parameters
Parameters Measured deviations
Q980 1st position in the main axis
Q981 1st position in the secondary axis
Q982 1st position in the tool axis
Q983 2nd position in the main axis
Q984 2nd position in the secondary axis
Q985 2nd position in the tool axis
Q986 3rd position in the main axis
Q987 3rd position in the secondary axis
Q988 3rd position in the tool axis
Q994 Angle in the I-CS
Q995 Angle in the coordinate system of the rotary table
Q996 First diameter
Q997 Second diameter
Parameter
value
Workpiece status
Q183 = -1 Not defined
Q183 = 0 Pass
Q183 = 1 Rework
Q183 = 2 Scrap
9
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
329