Basic information | Control model, software and features
New cycle functions 81760x-16
Further information: User's Manual for Programming of Measuring
Cycles for Workpieces and Tools
Cycle 1400 POSITION PROBING (ISO: G1400)
This cycle allows you to probe a single position. You can transfer
the acquired values to the active line of the preset table.
Cycle 1401 CIRCLE PROBING (ISO: G1401)
This cycle allows you to determine the center point of a hole or a
stud. You can transfer the acquired values to the active line of the
preset table.
Cycle 1402 SPHERE PROBING (ISO: G1402)
This cycle allows you to determine the center point of a sphere.
You can transfer the acquired values to the active line of the
preset table.
Cycle 1412 INCLINED EDGE PROBING (ISO: G1412)
This cycle allows you to ascertain a workpiece misalignment by
probing two points on an inclined edge.
Cycle 1493 EXTRUSION PROBING (ISO: G1493)
This cycle allows you to define an extrusion. With an active
extrusion, the control repeats the touch points along a direction
over a defined length.
1
HEIDENHAIN | TNC620 | Klartext Programming User's Manual | 01/2022
45
To Next Page
Loading...
