Hioki 3166 - Page 165

143
────────────────────────────────────────────────────
9.3 Functions That Support Remote Control
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
"Print start" is sent to the
printer during this interva
l.
5 V (open)
0 V ( closed
)
At least 300 m
s
Printing Control
NOTE
5 V (open
)
0 V (closed
)
At least 300 ms
"Save start" is sent to
the FD during this interval.
Control for Saving Data on Floppy Disk
NOTE
CAUTIO
N
・The remote control functions are enabled even when the key lock feature is
engaged.
・Input clean signals free of chattering for the control signals. Note that norma
l
operation is not possible with a pulse of less than 300 ms.
(3) Printing
This remote control function is used to manually initiate the printing of
measurement data on the printer.
The operation of the control signal is illustrated below.
The printer must already be connected to the 3166. In addition, the setting
for the device connected to the RS-232C interface must be "printer." Make all
other necessary settings as well. (Refer to section 8.2.11, "RS-232C device")
(4) Saving data on a floppy disk
This remote control function is used to manually save measurement data on a
floppy disk.
The operation of the control signal is illustrated below.
An 9595 FDD UNIT must be connected to this power meter before attempting
to use this function.