Hioki 3166 - Page 206

184
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Demand measurement start time setting
Synta
x
DEMand:STARt:TIME data1,data2,data3,data4,data5
dat
a
data1 Year 1980 to 2079 (numerical data in NR1 format)
data2 Month 1 to 12 (numerical data in NR1 format)
data3 Day 1 to 31 (numerical data in NR1 format)
data4 Hours 0 to 23 (numerical data in NR1 format)
data5 Minutes 0 to 59 (numerical data in NR1 format)
Functio
n
Sets the demand measurement start time.
Not
e
If a time that has already passed is set, demand measurement does not
begin.
Erro
r
・An execution error occurs if a nonexistent date is set.
・In the following circumstances, a device dependent error is generated:
If an attempt was made to execute this command while waiting for or
during demand measurement.
In the event of a system error.
Exampl
e
Transmission
":DEM:STAR:TIME 1997,1,8,20,45"
Sets the demand measurement start time to 20:45:00 on January 8, 1997.
■ Demand measurement start time query
Synta
x
DEMand:STARt:TIME?
Functio
n
The demand start time is returned in (data1) through (data5). (All as NR1
numeric data.)
Respons
e
synta
x
If headers are ON
If headers are OFF
":DEMAND:START:TIME data1,data2,data3,data4,data5"
"data1,data2,data3,data4,data5"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":DEM:STAR:TIME?"
":DEMAND:START:TIME
 1997,1,8,20,45"
":DEM:STAR:TIME?"
"1997,1,8,20,45"
D
EMand:STARt:TIME
D
EMand:STARt:TIME?