Hioki 3166 - Page 243

221
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
Functio
n
Returns data on the measurement items specified by (data1)to(data10).
Respons
e
synta
x
Headers
U1,U2,U3,Uave,I1,I2,I3,Iave
data1
P,Q,S,PF,F
data2
U1max,U2max,U3max,I1max,I2max,I3max
data3
Pmax,Qmax,Q-max,Smax,PFmax,PF-max,Fmax
data4
U1max DATE,U1max TIME,U2max DATE,U2max TIME,
U3max DATE,U3max TIME,I1max DATE,I1max TIME,
I2max DATE,I2max TIME,I3max DATE,I3max TIME,
OUTPUT DATE,OUTPUT TIME
data5
Pmax DATE,Pmax TIME,Qmax DATE,Qmax TIME,Q-max DATE,
Q-max TIME,Smax TIME,Smax DATE,PFmax DATE,PFmax TIME,
PF-max DATE,PF-max TIME,Fmax DATE,Fmax TIME,
START DATE,START TIME
data6
U1min,U2min,U3min,I1min,I2min,I3min
data7
Pmin,Qmin,Q-min,Smin,PFmin,PF-min,Fmin
data8
U1min DATE,UImin TIME,U2min DATE,U2min TIME,
U3min DATE,U3min TIME
data9
Pmin DATE,Pmin TIME,Qmin DATE,Qmin TIME,Q-min DATE,
Q-min TIME,Smin DATE,Smin TIME,PFmin DATE,PFmin TIME,
PF-min DATE,PF-minTIME,FminDATE,FminTIME
data10
Data formats
Date
Hours
Max and min data, PF
,
F
Instantaneous value
data except PF,F
yy/mm/dd
hh:mm:ss
+123.4E+0(9 characters in all)
+123.45E+0(10 characters in all)
Not
e
・"qtime" for (data5) specifies the time at which this query was received.
・"start" for (data6) specifies the starting time of the measurement for the
minimum/maximum values.
・The message unit separator can be switched from a semicolon (";") to a
comma (",") with the "TRANsmit:SEParator" command.
Erro
r
In the following circumstances, a device dependent error is generated:
If the measurement mode is not Normal measurement mode.
In the event of a system error.
When no items at all are specified.
Exampl
e
Transmission
":MEAS:NORM? 255,0,0,0,0,0,0,0,0,0"
Inquires about "U1", "U2", "U3", "Uave", "I1", "I2", "I3" and "Iave" from the
measurement data.