Hioki 3166 - Page 307

285
────────────────────────────────────────────────────
16.2 Normal Measurement Mode
────────────────────────────────────────────────────
1
5
1
6
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
A
CAUTIO
N
Because circuit operations are not settled immediately after power is restored,
the correct minimum and maximum instantaneous values are not displayed.
Press the Data Reset to clear the minimum and maximum values.
1
6.2 Normal Measurement Mode
(1) Data and setting conditions that are retained
1. Measurement data
The minimum and maximum values just before power was lost are retained.
If the display data was being held when power was lost, all of the data that
was being held is retained.
2. Setting conditions
The setting conditions when the power was lost are retained.
(2) Operation after power is restored
Once power is restored, the Normal Measurement mode screen is displayed
and instantaneous value measurement resumes. If display data was being
held when power was lost, that data is displayed and measurement resumes.
The FDD unit does not perform any operation.