HP StorageWorks P9000 - Disk Arrays Reference Guide

Table 2 Basic Information in Audit Log File (continued)
File 2 (DKC)File 1 (SVP)ItemNo.
The result of the received commands.
• Normal end. The authentication has ended
normally.
• Error. The authentication has ended
abnormally.
• Accept. Received the commands from the host.
• Reject. Rejected the commands from the host.
The result of your operation.
• Normal end. The operation has ended
normally.
• Error (xxxx-yyyyy). The operation has
ended abnormally.
• Warning (xxxx-yyyyy). The operation
has partly ended abnormally or was
canceled during the operation.
Error codes "xxxx-yyyyy" appear only for
Remote Web Console operations.
Result12
• A host name is output for commands from
hosts through SVP.
• A WWN is output for the FC-SP
authentication.
• A WWN is output for commands from
open-system hosts.
• A serial number is output for commands
mainframe system hosts.
• If a command comes from other storage
system, the WWN or serial number of the
storage system is output.
An IP address (IPv4 or IPv6) is output for
Remote Web Console, RMI AP and SVP
operations. The IP address may be that of
the proxy server or the router depending
on the configuration of the connected
network.
No output for RM AP operations. No
output when the user name is <System>.
When both IPv4 communication and IPv6
communication can be used:
Even when you specify the IPv6
communication address of the SVP on
Remote Web Console computer,IPv4
communication is used to Remote Web
Console secondary window, and also the
audit log files show IPv4 communication
addresses.
For details about configuring only IPv6
communication, see the section describing
IPv6 communication in HP StorageWorks
P9000 Remote Web Console User Guide.
Host
Identification
13
• An internal-use ID is output for open-system
hosts.
• An LPR number is output for mainframe system
hosts.
• 0x0000 is output if a command comes from
other storage system.
• No output for other commands.
No outputApplication
Identification
14
Same as File 1.The serial number of the saved log
information (0000000000 to
4294967295). When the number
reaches 4,294,967,295, it is reset to
0000000000.
Serial number15
Detailed Information
Detailed information in the audit log file 1 (SVP) contains index and setting values. Detail information
in the audit log file 2 (DKC) contains command names and parameters received from a host.
The following shows the symbols used in the detailed information.
Audit log file format 15

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English