Table 30 Remote Copy > Continuous Access Journal
Audit Log OutputGUI operation
Operation NameFunction NameDescriptionSubmenu
Journal-Vol (Note 1)Cnt Ac-JEdit JNL VolumesJournal Operation
Change-JNL-Option (Note 1)Cnt Ac-JChange JNL Option
Journal-Vol (Note 1)Cnt Ac-JDelete JNL Groups
Change-Mirror-Option (Note 1)Cnt Ac-JChange Mirror Option
Pairsplit-r (Note 1)Cnt Ac-JPairsplit-r
Pairresync (Note 1)Cnt Ac-JPairresync
Pairsplit-S (Note 1)Cnt Ac-JPairsplit-S
R-Cmd.Dev. (Note 1)Cnt Ac-JAssign Remote Command
Device
R-Cmd.Dev. (Note 1)Cnt Ac-JRelease Remote
Command Device
Paircreate (Note 1)Cnt Ac-JPaircreatePair Operation
Pairsplit-r (Note 1)Cnt Ac-JPairsplit-r
Pairresync (Note 1)Cnt Ac-JPairresync
Pairsplit-S (Note 1)Cnt Ac-JPairsplit-S
Pair-Option (Note1)Cnt Ac-JChange Pair Option
Add RCURCUAdd Disk Controller (DKC)DKC Operation
Change RCU OptionRCUChange Disk Controller
(DKC) Option
Delete RCURCUDelete Disk Controller
(DKC)
Add Path (Note 1) (Note 2)RCUAdd Path
Delete Path (Note 1) (Note 2)RCUDelete Path
Edit Ports(Attr)PROVChanging port attribute
(Target, Initiator, RCU
Target)
System-Option (Note 1)Cnt Ac-JChange System OptionOptional Operation
Note 1: When you apply two or more settings of the same type to the storage system at the same
time, the log information is output as one entry.
Note 2: If one or more settings end abnormally when you have applied at one time, the output
log information is Error, not Warning.
204 Audit log user operations
To Next Page
Loading...
Need help?
General