3.7 Address Configuration
A3-50
ME0384-4A
(4) Acceleration/deceleration [G]
Input the acceleration/deceleration rate at which the actuator is to travel. Use a value within the
rated range.
Take care, as it is possible to input a number larger that the catalog rated value.
Reduce the number if the object to be conveyed vibrates during acceleration/deceleration,
causing problems.
Acceleration/deceleration is rapid when the number is increased and gradual when it is
decreased.
Caution
● For acceleration/deceleration, refer to "Appendix Chapter 2 Connectable Actuators", or
to the actuator catalog or instruction manual, and set so that the specified
acceleration/deceleration is not exceeded.
● Input appropriate values so that excessive shock and vibration are not applied to the
actuator, in consideration of the installation conditions and the shape of the conveyed
object.
● Increasing this number greatly affects the allowable payload. Also, take care as this can
cause failure.
0.3 G
0.2G
To Next Page
Loading...
Need help?
General
