5.1 Overview
A5-1
ME0384-4A
Chapter 5 200V Driver Unit 200V Power Supply Unit
5.1 Overview
[200V Driver Unit]
The 200V driver unit is a controller dedicated for R Unit. The maximum number of axes available
to control with one unit of the driver unit is one axis. The basic features and performances are the
same as those for SCON controllers.
It is a controller to perform control in the field network communication via the gateway unit
explained in Chapter 3.
The unit is to be installed on the right from the front view of the 200V power supply unit. It is
available to perform control 16 axes at the maximum in combination with the 24V driver unit and
the EC connection unit.
(Note)
Also, there is a 200V fan unit enclosed to the 200V driver unit.
Note: There is a limit to the wattage connectable. Refer to [Characteristics] for details.
[200V Power Supply Unit]
The power supply unit is dedicated for 200V AC (single-phase / 3-phase). It is necessary when
using the 200V driver unit.
The unit is to be installed on the right from the front view of the 24V driver unit and EC connection
unit. If only the 200V driver unit is to be used, allocate it on the right side of the gateway unit.
Also, there is a fan unit and terminal unit for 200V enclosed to the power supply unit.
[Characteristics]
■The unit is applicable for the battery-less absolute type, incremental type, index absolute type
and spurious absolute type.
■One unit of the driver unit can be applied to wattages from 60W to 750W.
■As it is equipped with a built-in regenerative resistor, there is basically no need of external
regenerative resistor.
■The wattage connectable is as shown below;
For single-phase 200V ····· Total wattage of actuators connected to 200V driver unit should be
1600W max.
For 3-phase 200V ··········· Total wattage of actuators connected to 200V driver unit should be
2400W max.
■Direct link among driver units makes drastically simple wiring work.
■Installation on DIN rails makes it easy to install to a control board.