3.7 Address Configuration
A3-63
ME0384-4A
(16) Wait time [s]
After completing travel, this sets the standby time until the next position No. operation starts.
Enabled only when "Connection No." is set.
This function can only be enabled in AUTO mode. When performing continuous operation with
PC software, use the easy programming function.
(17) Comments
Up to 20 alphanumeric characters can be input.
Input comments are saved to the controller.
(18) 1-line comment
Up to 56 alphanumeric characters can be input.
Right-clicking on the position data and enabling [One-row comment enable/disable setting] will
allow you to enter 1-line comments. Disabling it will clear any comment you have entered.
To edit a comment, type in the comment to display the setting screen. Enter a comment on the
setting screen and click OK.
To Next Page
Loading...
