Why repeater replies RPT and call sign on Icom Transceiver?
If the repeater replies 'RPT?' and the call sign of the destination repeater after your call on the Icom Transceiver, the repeater cannot connect to the destination repeater. Check the repeater setting. Alternatively, the repeater may be busy, so wait a while and try again.
Why the displayed frequency is erroneous on Icom ID-51A?
If the displayed frequency on your Icom Transceiver is erroneous, the CPU may have malfunctioned. Reset the transceiver. Alternatively, external factors may have caused a fault; remove and reattach the battery pack/case.
Why DV and FM icons blink on Icom Transceiver?
If the “DV” and “FM” icons alternately blink on your Icom Transceiver, an FM signal is being received while in the DV mode. Use a different operating frequency until there are no FM signals on the original frequency.
Why repeater replies RX or RPT and access repeater's call sign on Icom ID-51A Transceiver?
If, after your call, the repeater replies ‘RX’ or ‘RPT?’ and the access repeater’s call sign on your Icom Transceiver, your own call sign (MY) has not been set. Set your own call sign (MY). Alternatively, your own call sign (MY) has not been registered on a gateway repeater, or the registered contents do not match your transceiver’s setting. Register your own call sign (MY) on a gateway repeater, or confirm the registration of the call sign.
Why the SUB band audio signal is muted on Icom ID-51A?
If the SUB band audio signal is muted on your Icom Transceiver, the combination of operating band and mode may be incorrect. Change the settings.
Why distorted noise is heard when earphone is used on Icom ID-51A?
If a distorted noise is heard when using the earphone with your Icom Transceiver, the earphone mode may be OFF. Turn ON the earphone mode.
Why charging is impossible at power ON on Icom ID-51A Transceiver?
If charging is impossible while the power is ON for your Icom Transceiver, the “Charging (Power ON)” setting is likely OFF (default). Set the “Charging (Power ON)” setting to ON in the Function Menu.
What to do if the digital code squelch (CSQL) does not work on my Icom Transceiver?
If the digital code squelch (CSQL) does not work, the wrong digital code may be set. In this case, set the correct digital code.
Why is sensitivity too low on my Icom Transceiver?
If the sensitivity is too low, and only strong signals are audible, the coaxial cable may not be connected or is shorted (if an external antenna is used). Check the coaxial cable connection or replace it with a new one.
General| Frequency Range | 144-148 MHz, 430-450 MHz |
|---|---|
| Antenna Connector | SMA |
| GPS Receiver | Yes |
| Waterproof | IPX7 |
| Modes | FM, DV |
| Weight | 255 g |
| Memory Channels | 1304 channels |
| Output Power | 5W (High), 2.5W (Middle), 0.5W (Low) |
To Next Page
