ICON A5 - Salt-Away Rinse

STRUCTURES / RINSE AFTER SALT WATER OPERATIONS 4-9
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 4
2. Remove nozzle attachments from garden hose and set water flow to a low gentle rate.
3. Direct flow of water over all metal parts on each side of the joint.
4. Use a towel to dry surfaces.
VERIFICATION METHOD:
Task is done when steps are complete and all surfaces are dry.
RELATED INFORMATION:
"Rinse After Salt Water Operations" on page 4-4
4.2.5 Salt-Away Rinse
Use this task to perform a Salt-Away rinse according to the corrosion prevention schedule (See
Related Information).
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
Consumables
None
TASK INSTRUCTIONS:
1. Use Salt-Away product per the manufacturer’s instructions to rinse aircraft using overall exterior
rinse procedure. (See “Overall Exterior Rinse” on page 4-5.)
VERIFICATION METHOD:
Task is done when overall exterior rinse procedure is completed.